News

Some problems and solutions in the construction process of steel structure engineering (3)

Deformation of component 1. The component is deformed during transportation, resulting in dead or gentle bending, which makes the component unable to be installed. Cause analysis: a) The deformation produced when the components is made, generally presented as slow bending. b) When the componen... Read More

How to waterproof steel structure?

How to waterproof steel structure? We all know that space frame steel structure is the new building structure, widely used in life popularly. But for space frame steel structure, what about the waterproof effect? Let’s get to know it in detail. Space frame steel structure can be used in lar... Read More

Some problems and solutions in the construction process of steel structure engineering (2)

Connection problems 1. high strength bolt connection 1) The bolt equipment surface does not meet the requirements, resulting in poor installation of bolts, or the fastening degree of bolts does not meet the design requirements. Cause analysis: a). Here are floating rust, oil and other impurit... Read More

What is the most indispensable technology on the space frame?

In the steel structure products, the space frame structure is not uncommon, they can be used in life, but also can be used in the construction of the building. And in both that occasion and use, we should note that this structure is not likely to lack the use of the following technologies. First,... Read More

Major industrial project observation meeting, OM Steel Construction gave a perfect answer

From December 18 to 19, the observation and comment meeting of the major industrial projects and the beautiful town “Eight one” project was held to observe the major projects around the region, and the enterprises published their work “report card”. District party committe... Read More

Some problems and solutions in the construction process of steel structure engineering(1)

1, The production problem of components The plates used for the portal steel frame are very thin, some thin to 4mm. The cutting method should be chosen to avoid flame cutting for the blanking of thin plates. Because flame cutting will cause a lot of wavy deformation of the plate edge. At present,... Read More